Instruction manual

ControlWave Micro Display/Keypad Instruction Manual (D5135)
Chapter 2 – Installation & Configuration
Caution
To ensure safe use of this product, please review and follow the
instructions in the following supplemental documentation:
 Supplement Guide - ControlWave Site Considerations for
Equipment Installation, Grounding, and Wiring (S1400CW)
 ESDS Manual – Care and Handling of PC Boards and ESD
Sensitive Components (S14006)
WARNING
EXPLOSION HAZARD
When the ControlWave-series controller is situated in a hazardous
location, turn off power before servicing or replacing the unit and before
installing or removing wiring.
Do not connect or disconnect equipment unless the power is switched
off or the area is known to be non-hazardous.
In most cases, the display/keypad assembly arrives factory-installed in
the enclosure.
If you purchase the display/keypad assembly separately, and want to
install it yourself, follow the installation drawings. See Figure 2-1 for
the dual-button keypad, and Figure 2-2 for the 25-button keypad.
Once you’ve installed the display/keypad assembly, connect the display
cable between the RJ-45 jack (J1) on the display/keypad assembly and
the RJ-45 display interface jack on the controller.
2.1 Configuring Your Application to Work with the Display/Keypad
You configure the Display/Keypad in ControlWave Designer by adding
the DISPLAY function block to your project, and configuring its
parameters. The amount of configuration required varies depending
upon the type of keypad (25-button or dual-button) and the operating
mode you choose. See the DISPLAY function block online help pages
in ControlWave Designer for instructions.
Issue Nov-2010 Installation & Configuration 2-1