Instruction manual

ControlWave Micro Display/Keypad Instruction Manual (D5135)
Note: The default username is SYSTEM.
4. Enter a Password for the chosen user using the [0] through [9] keys.
For security, asterisks appear instead of digits as you enter the
password. (See Figure 4-5B.) If you make a mistake, press [F1] and
try again (or use the delete key to delete the previously pressed key
action). The default password is 666666. After typing the password,
press [ENTER] to log on.
Note: If your password is not recognized, the display erases the
asterisks after you press [ENTER]. Check your password and try
again.
Figure 4-5. Logging On
5. Once you log on successfully the display looks like Figure 4-5C.
6. If the display shows Logged On with Read/Write Access on lines
1 and 2, you can read and write variable values and status flags. If
the display shows Logged On with Read Only Access on lines 1
and 2, you cannot change variable values or status flags; you are
only permitted to read variable information. To log on again as a
user with read/write privileges, log off by pressing the [INIT] key,
and log on again, with a username/password combination that
supports read/write privileges.
Issue Nov-2010 Using the 25-button Display/Keypad 4-5