Instruction manual

ControlWave Gas Flow Computer (GFC Plus) Instruction Manual (CI-ControlWave GFC Plus)

Revised Feb-2013 Installation 2-23

2.5 Installing the Rechargeable Battery and Solar Panel Harness

You must remove the rechargeable sealed lead-acid battery from its

shipping carton and install it on its mounting bracket within the

enclosure as illustrated in Figure 2-11.

Figure 2-11. Enclosure with Sealed Lead-acid Battery Installed

Remove connector TB1 from the CPU/System Control Board.

2. Remove the lead-acid battery from its shipping carton.

3. Install the lead-acid battery (on end) as illustrated in Figure 2-11.

Note: Make sure the lead-acid battery is fully charged before

you install it.

4. Route the solar panel power wiring harness into the enclosure

through the solar power conduit fitting (see Item 5 of Figure 2-2).