Instruction manual

ControlWave Gas Flow Computer (GFC Plus) Instruction Manual (CI-ControlWave GFC Plus)
Revised Feb-2013 Installation 2-7
Figure 2-3. Side View of ControlWave GFC Plus Mounted
 Only connect power wiring after the unit is mounted and properly
grounded.
 I/O, power, and communication cabling enters the bottom of the unit
through conduit or special function fittings. You can also route I/O
wiring through the left side of the unit (right when facing the front)
instead of the bottom; this requires that you remove the left side hole
plug and replace it with a ½” conduit fitting swapped out from the
bottom of the unit.
Refer to Figure 2-4 for mounting dimensions.