Troubleshooting guide

Getting Started • Homeowner Manual
7
C. Temporary versus Permanent Hold
A temporary hold can be set when operating in any mode except
for OFF. A temporary hold is set by pressing the
or on the
thermostat to adjust the desired temperature. The SET AT indication
of the temperature setpoint will change to HOLD AT and a message
will be cycled in the thermostat messaging display area to confirm
that a temporary hold is set. A temporary hold setpoint will then be
maintained until the start of the next programmed time period or the
RUN softkey is pressed.
A permanent hold can be set when operating in any mode except
for OFF. To set a permanent hold, change the temperature just like
setting a temporary hold. When the desired setpoint is entered, the
user will have approximately 4 seconds to press the PERM HOLD
softkey to convert the temporary hold into a permanent hold. The
SET AT by the setpoint will change to HOLD AT and a message will
be cycled in the thermostat messaging display area to confirm that
a permanent hold is set. If the PERM HOLD softkey is not pressed
within 4 seconds, the hold will remain a temporary hold. A permanent
hold setpoint will override the programmed setpoints and time periods.
A hold will end whenever the RUN softkey is pressed.