Specifications

I-2 • E2 RX/BX/CX I&O Manual 026-1610 Rev 10 06-APR-2010
advisory log
accessing 12-11
viewing 12-11
date and time stamp 12-11
dial-out 10-22
The Alarm Output 10-22
The Display Line 10-22
The Echelon Network 10-22
forced to normal. See Alarms, reset to nor-
mal.
resetting 12-13
reset-to-normal 12-12
return-to-normal 12-12
state, in advisory log 12-11
the Alarm Annunciator 10-22
Alternate I/O Formats 10-26
Analog Sensor Control 11-37
Anti-Sweat
case-controlled 11-13
dewpoint input 11-14
how setpoints work 11-14
how anti-sweat works 11-44
setup 11-44
zones, definition of 11-44
Application Setup 10-25
-B-
Base Log Group 11-17
Battery 4-5
enable switch 4-5
low 4-5, 12-17
replacement 4-5
test 4-5
Baud Rates 10-12
E2
RS-232 port 10-12
E2, setting for I/O Network 10-12
I/O Network 6-3
8DO 6-3
8IO 6-3
ARTC 6-3
E2 6-3
IRLDS 6-3
Blue "R". See Cold Reset.
Board Types 6-1
Boards on the I/O Network 10-2, 10-15
Box to Box Communications 7-1
Box-To-Box 1-4
Building Controller 1-1
Buttons
cold reset 10-1
reset 10-1
BX Capabilities 1-1
BX Home Screen 12-1
-C-
Case Circuits, Standard. See Standard Circuits.
Case Control Circuits
associating CC-100s with 11-16
defrost in 11-12
overview 11-10
Case Controllers
anti-sweat control 11-13
associating with Case Control Circuits 11-16
CC-100H
defined 2-12, 11-10
CC-100LS
defined 2-12, 11-10
CC-100P
defined 2-12, 11-10
CCB 9-18
clean mode 11-14
CS-100
defined 2-12, 11-10
defrost 11-12
pump down delay 11-12
defrost types 11-12
digital sensors
installing 9-16
dual temp control 11-14
EEPRs
recovery mode 11-12
fail-safe mode 11-15
fan control 11-14
humidity sensor installation 9-16
inputs 9-16
installation guide 8-6
light control 11-14
mounting dimensions 3-5
power modules
wiring 9-17
wiring schematic 9-17
problems with cases F-6
recovery mode