Specifications

Set Up Applications Quick Start • 10-27
parameter stored inside the controller. Setpoints can be
programmed from any application setup screen.
To enter setpoints from a Setup screen:
1. Press  (SETUP) from the desired applica-
tion’s Status screen. (If starting from the Home
screen, move the cursor to the desired applica-
tion’s value and press
 to open the Actions
Menu. Choose Setup. This will take you to the
Setup screen.)
2. Once inside the application’s Setup screen, look
for the Setpoints option in the index tabs along
the top of the screen.
3. Use  (NEXT TAB) to tab over and the Set-
points box of your application will open.
10.18.2.3 Navigating the Setup Screen
The Setup utility is the interface used to change set-
tings and setpoints, and define inputs and outputs in the
E2. Figure 10-11 and Figure 10-48 show a typical Setup
screen and its primary elements.
Index Tabs
The ten boxes at the top of the screen labeled C1
through C0 are known as the index tabs. These tabs pro-
vide a short index of the screens that are used to set up the
current application. The numbers C1 through C0 represent
the screen numbers (C1 being screen 1, C2 being screen 2,
and so on).
Each of the Setup screens that you may access will
have a name beside its number. But as in Figure 10-11 and
Figure 10-48 for example, you will notice some tabs have
names, while others are blank.
As you move through these screens within the Setup
Editor, the highlight will move to different tabs to indicate
which screen is being displayed.
• Pressing  (PREV TAB) will back-up the order
of the screens.
• Pressing  (HOME) at any point will take you
to the Main Status (Home) screen.
These screens (C1 through C0) contain all of the set up
information that is associated with the selected suction
Figure 10-47
- Setpoints Box
Figure 10-48 - Typical Setup Screen (RX version shown)
TIP: To see each screen in a typical setup for
the E2 RX controller, start from the Main Sta-
tus (Home) screen.
1. Position the cursor somewhere inside the Suc-
tion Groups section and press
 and 
(Setup), or just  (SETUP) from the Home
screen. The General Setup screen will be dis-
played.
2. Press  (NEXT TAB) to move the cursor
to Setpoints. The Setpoints Setup screen is dis-
played.
3. Press  again and the Inputs Setup screen
comes up.
4. Press  a few more times to see the rest of
the Setup menu screens. When the C0 tab
(MORE) is highlighted, there may be more
than one extra Setup screen. Press
 + 
(zero) to see a list of all Setup screens for that
application.
5. Keep pressing  while taking note of the
extra screens until C1 is highlighted once
more.