Instructions / Assembly

11
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF320
5. Final Assembly
SWITCH
HOUSING COVER
SWITCH HOUSING
COVER CONNECTOR
MOTOR HUB
CONNECTOR
SWITCH
HOUSING
ADAPTER
Figure 16
5.2
The two connectors are keyed and color-coded and must
be mated correctly (same color-to-color) before they can
be engaged.
Engage the connector of the switch housing cover with the
motor hub connector (Figure 16).
Make sure the connector latch closes properly.
SWITCH HOUSING
COVER
POSITION COVER
ON ADAPTER
LARGE SLOT
#6-32 x 0.375"
FLAT HEAD
SCREWS (3)
Figure 17
5.3
Tuck all the wires and connectors into the switch housing
adapter.
Position the switch housing cover so that the reverse
switch fits into the large slot of the switch housing adapter
(Figure 17).
Align the three screw holes of the switch housing cover.
Secure the switch housing cover to the switch housing
using the three #6-32 x 0.375” flat head screws
(supplied in parts bag) (Figure 17).
M
OTOR HUB
R
OTATE
A
DAPTER
C
LOCKWISE
#6-32 x 0.312"
PAN HEAD SCREW
MOTOR HUB
CONNECTOR
S
WITCH HOUSING
ADAPTER
Figure 15
5.1
Remove one #6-32 x 0.312” pan head screw from the motor
hub and retain for later use.
Loosen the other two #6-32 x 0.312” pan head screws on
the motor hub for the installation of the switch housing
a
dapter.
Place the motor hub connector through the center hole of the
switch housing adapter.
Place the switch housing adapter onto the motor hub,
aligning the three screw holes (Figure 15).
Rotate the switch housing adapter key hole slots clockwise
to engage both loosened screws (Figure 15).
Reinstall the previous removed screw.
Secure the switch housing to the motor hub by tightening the
three switch housing screws.
Spare #6-32 x 0.312” pan head screw supplied in parts bag,
if needed.