Setup guide

Setting up the Hardware
9
3. Remove the CPU Module from its carton and install it into Chassis slot 2, i.e., the second slot
from the left end of the installed unit. CPU Module DIP Switches may be configured before
or after the module has been installed into the Chassis. (see Section 2.3.3. of CI-
ControlWaveEXP).
NOTE: For the initial configuration activities described in this manual, we recommend you leave
most of the CPU switch settings in their default positions, as set at the factory:
Comm.
Port 1 (J1)
Comm.
Port 2 (J2)
Lithium
Battery
3.6V
950mA-hr
½ AA Cell
Ethernet
Port 1 (J3)
Port 80
Display
Reset
Switch
SW1
SW3
SW1
SW3
Enlarged detail
of CPU switch
banks
By default, SW1
switches should
all be 'ON'
this rack is part of
a redundant
p
air.
unless
Leave all SW3
CPU switches
in default 'OFF'
position, excep
t
for #4.
UNIT A / unit B
Unused
Unused
Redundancy DISABLE / enable
Watchdog circuit ENABLE/disable
Soft switches write UNLOCK / lock
Soft switches USE / ignore
Diagnostics DISABLE / enable
NORMAL / updump
static memory RETAIN / initialize
(CAPITALIZED entry
indicates ON position)
(CAPITALIZED entry
indicates ON position)
recovery mode ENABLE/disable
ENABLE/disable battery backup