Setup guide

Setting Configuration Parameters
20
Saving Your Configuration Parameter Changes to the I/O Rack
To save your configuration
changes, click on the [Save to
Rtu] button. This button saves
ALL entries in the pages of
the Flash Configuration Utility
to the I/O Rack. NOTE: If you
haven't signed on prior to
clicking on this button, you
will be prompted to do so.
A prompt will now appear
asking if you want to save the
parameter changes to the
NETDEF file. You should
click on [No], since the I/O
Rack is not considered a node
in the NETDEF file.
At this point, you can click on [Close] to exit the Flash Configuration Utility.
You MUST power-off then re-start to activate the newly saved parameters
At this point, you should power off, and then re-start the I/O Rack for the newly saved
parameters to be activated.