Setup guide

Setting Configuration Parameters
16
Defining IP Parameters
Click on the 'IP Parameters' tab, and specify the IP address of the host ControlWave controller in
the "IP ADDR A" field; NOT the Network Host PC (NHP).
If another ControlWave controller serves as a redundant standby unit for the host controller,
enter the redundant unit's IP address in the "IP ADDR B" field.
NOTE: For more information on what the other parameters on this page mean, please refer to
Chapter 5 of the Open BSI Utilities Manual (document# D5081).
NOTE: The “Challenge Protocol Default Username” refers to a username defined on the
‘Security’ page of the Flash Configuration utility. The same combination of the
username/password defined on that page must also be defined in the host ControlWave unit in
order for a successful sign-on, and communications between the host and the I/O rack. If no
default username, is assigned, the system will attempt to use, “SYSTEM” and “666666” as the
username/password, and failing that, the first defined username/password combination in the
system. Redundancy, PAP/CHAP protocols, and host-to-I/O rack communications all make use
of this username/password combination.
For the I/
O
rack, this is the IP address
of the host ControlWave controller;
the Network Host PCnot