Setup guide

Setting Configuration Parameters

Signing On in the Flash Configuration Utility

Enter the username and password and click on

[OK].

Once you have signed on, you can proceed to:

• Define an Ethernet Port

• Define IP Parameters

• Define Application Parameters

• Save Changes to the I/O Rack

• Turn off the I/O rack and re-start it

These steps will be covered in the pages which follow.

You must click here to sign-on

with a username and password

in order to access any flash

parameters.

Tabs for

calling up

other pages

For purposes of this configuration we are leaving the

local address at a value of "1". If we were configuring

I/O racks which communicated via MODBUS, the

local address would be used as the MODBUS slave

add

ess