Setup guide

Setting Configuration Parameters
13
Turn off auto local address detection
Use "1" as the local address
Choose
'CWave_RIO'
Finall
y
, click on [Finish]
4. First, turn off auto local address detection by answering "No" to the question. Then specify
'1' as the local address, and 'CWave_RIO' as the RTU type. Finally, click on [Finish].
5. At this point, LocalView will create a temporary network with a single 'RTU'. Right-click on
the icon, then choose RTUÆ RTU Configuration Parameters from the pop-up menus.
This will call up the Flash Configuration Utility.
Right-click on the ‘CWave_RIO’ ico
n