Instruction manual

2-28 / Installation CI-ControlWaveLP
"Would you like to use auto baud rate detection?" / "What baud rate would you like
to use?"
If you know which baud rate to use, answer no for auto baud detection, and specify the
baud rate. If you do not know which baud rate to use, choose auto baud detection.
[Advanced Parameters]
See the ‘Advanced Communication Parameters Dialog Box’ section, later in this chapter
for details on this.
Figure 2-26 - Communication Setup: Step 1 Menu
Click on the [Next] pushbutton to activate the next wizard (see Figure 2-27).
Step 2 - Flash RTU Setup
In the Flash RTU Setup Wizard (see Figure 2-27), complete the fields as described, below:
"What is the type of the RTU?"
Use the list box to select the type of controller you are connected to. In this case, you
should only choose from among the ControlWave-series options:
Select this option: For this type of unit:
ControlWaveLP
ControlWaveLP Low Power RTU
"What is the local address of the RTU that you would like to connect to?"
Select the BSAP local address of the ControlWave unit (from 1 to 127) using the list
box provided.
Click on the [Next] push button to activate the Flash Data Setup Wizard.