Instruction manual

ControlWave ExpressPAC Instruction Manual (CI-ControlWave EPAC)
vi Contents Issued Mar-2011
4.4 Creating and Maintaining Backups ...........................................................................................4-3
4.4.1 Creating a Zipped Project File (*.ZWT) For Backup .....................................................4-4
4.4.2 Saving Flash Configuration Parameters (*.FCP)..........................................................4-5
4.4.3 Backing up Data............................................................................................................4-6
Chapter 5 – Service and Troubleshooting 5-1
5.1 Upgrading Firmware..................................................................................................................5-2
5.2 Removing or Replacing Components .......................................................................................5-5
5.2.1 Accessing Modules for Testing.....................................................................................5-5
5.2.2 Removing/Replacing the CPU/System Controller Board and the Process I/O Board..5-5
5.2.3 Removing/Replacing the Primary Battery System........................................................5-6
5.2.4 Removing/Replacing the Backup Battery .....................................................................5-7
5.2.5 Enabling / Disabling the Backup Battery.......................................................................5-8
5.2.6 Removing/Replacing the Case-Mounted Radio or Modem ..........................................5-9
5.3 General Troubleshooting Procedures.......................................................................................5-9
5.3.1 Checking LEDs .............................................................................................................5-9
5.3.2 Status Messages on LCD Display ..............................................................................5-10
5.3.3 WINDIAG Diagnostic Utility.........................................................................................5-11
5.3.4 Available Diagnostics..................................................................................................5-12
5.4 Core Updump..........................................................................................................................5-15
5.5 Calibration Checks..................................................................................................................5-17
Appendix A – Special Instructions for Class I, Division 2 Hazardous Locations A-1
Appendix Z – Sources for Obtaining Material Safety Data Sheets (MSDS) Z-1
Index IND-1