User Guide
88.....Avocent® Universal Management Gateway Appliance Installer/User Guide
To configure Digital Output notifications:
1. From the sidebar, go to Monitoring. Under the Notification Rules heading, check the boxes for
the events for which you want to trigger a digital output relay.
2. Click Apply.
NOTE: Digital Output (DO) relays are for events on the back of the appliance only.
3. From the sidebar, go to Monitoring - Notification Destinations and enter the Digital Output
name and location for Digital Output 1 and Digital Output 2.
4. Click Apply.
NOTE: Once the digital output relay has been triggered, use the override to reset it.
Sessions
The appliance allows multiple users to log in and run sessions simultaneously. The sessions screen
allows you to view all active sessions and delete any unwanted sessions. Click Sessions to view all
open sessions on the appliance.
To delete a session:
1. From the sidebar, click Sessions. The sessions screen appears and lists all appliance and
target sessions to the appliance.
2. Select the checkbox next to the session you want to delete, then click the Delete button. After
a few seconds, the sessions screen will redisplay the open sessions, minus the one you
deleted.
Support
From the sidebar, click Support to configure diagnostic logging. You can create and save a log file
that can be downloaded and sent to technical support. The log file contains debug information
necessary for appliance technical support.
To enable system monitoring:
1. Click Support.
2. Check the box to enable system monitoring.
3. Set the frequency in minutes and click Apply.
4. Check the box to enable SPaccess monitoring.