User Guide

Administration.....79
2. Under the Session Settings heading, use the drop-down menu to select the desired
resolution.
3. Click Apply.
4. If using a custom setting, click the Custom EDIDtab.
5. Select either File or List as the desired source.
a. If you have selected File, click Get File and choose the appropriate file.
b. If you have selected List, update the resolution list with the desired resolution from the
dropdown menus.
NOTE: The default resolution will apply to all sessions and UMIQmodules.
6. Click Apply.
UMIQ pass through
When the UMIQpass through is enabled, KVMsessions will connect directly to the UMIQmodule
IP instead of connecting through the appliance IP. This requires that firewall rule 512 be disabled
and will allow IPforwarding/routing from public networks to the appliance's private networks.
The pass through mode is disabled by default. Rebooting or upgrading an appliance, or restoring
an appliance image dump will not affect the status of the pass-through mode. Performing a factory
restore will reset the pass-through mode to its default state.
To enable UMIQpass through:
1. Click KVMManagement - UMIQPass-Through.
2. Check the box to enable UMIQ pass through mode and click Apply.
3. Click Firewall and NATfrom the sidebar. Select the box next to Forwarding Rule 512 and use
the drop-down menu to change the rule state to Not Active. Click Apply.
4. Create a static routing rule on the client PC or on an intermediary router to direct traffic to
private appliance networks.
-or-
Enable OSPF on the appliance to share routes to the private networks with your intermediary
routers. For more information, see OSPF and BGP on page 37.
Target groups
From the sidebar, click Targets - Target Groups. From this screen you can create group targets.
Click Add to create a new empty group, or select an existing group and click Delete to delete that
group.