User Guide

Administration.....59
NOTE: Sessions to generic SPs will proxy through the appliance in the same way as sessions to all other
SPs.
Discovery log
The discovery log displays the results of SPadd and SPdiscovery processes on the appliance.
The log chronologically displays the status of the add/discovery steps and will automatically update
as status changes occur.
To view the discovery log, from the Administration tab, click Targets - Discovery, then click the Log
tab.
Type Description
Filter Options
Method Defines whether the SPwas discovered, manually added or imported.
Credential Defines whether default credentials were used or manually supplied.
Status
Defines whether the SPis being discovered, was successfully discovered or an error
occurred during the discovery process.
Comment Definitions
Target Added The SPwas successfully added.
No ping
response
No SP is found.
Not
communicating
AnSP has been found but the appliance is unable to communicate with it.This is likely due
to IPMI being disabled on the SP. See Discovery on page 54.
Type/credentials
not found
The SPis not supported or valid credentials were not found from the Default Users list.
Discovery Log Definitions
For a single page of the Discovery Log, an administrator can filter the results using the Method,
Credential and Status drop-down menus. The columns can be sorted in ascending/descending
order by clicking on the column header. The refresh button will reset to default the filter and sort
options.
To filter the discovery log:
1. From the sidebar, click Targets - Discovery, then click the Log tab.
2. Use the drop-down menus to filter by Method, Credential and/or Status.
3. Click Filter.
NOTE: Clicking Refresh resets all the filtering parameters.