User Guide

52.....Avocent® Universal Management Gateway Appliance Installer/User Guide
Serial Settings
From the sidebar, click Targets - Port Configuration - Serial Settings to view or change the default
serial interface communication settings.
To configure serial mode settings:
1. For serial devices connected to a port, click Targets - Port Configuration - Serial Settings.
2. Select the port and click Serial Port Setting.
3. Use the drop-down menus to select the state, speed, parity, data-size, stopbits, flow and the
serial pinout type.
NOTE: The default settings are:Speed = 9600, Parity = None, Data = 8, Stop bits = 1, Flow Control =
None.
4. Click Apply.
Network Settings
From the sidebar, click Targets - Port Configuration - Network Settings to view or change the
default network virtual interface communication settings.
To configure virtual interface network mode settings:
1. Click Targets - Port Configuration - Network Settings.
2. Use the drop-down menu to enable or disable the network interface.
3. Enter the IP address, broadcast address and MTUin the appropriate fields.
4. Click Apply.
NOTE: IPaddresses in CIDRformat will utilize a standard decimal notation address (192.168.0.1) with the
subnet mask represented by the number of network bits in the mask.
(255.0.0.0 = /8, 255.255.0.0 = /16, 255.255.255.0 = /24).
To create a custom interface:
1. Click Targets - Port Configuration - Network Settings.
2. Under the Custom Interfaces heading, enter the name for the private interface.
3. Enter the broadcast address.
4. Click Add.