User Guide

Initial Appliance Setup.....23
NOTE: If using DHCP, you must first find the IP address assigned to the appliance by looking at the DHCP
leases on the network DHCP server. Enter https://<appliance IP> in your browser to connect to the
appliance.
To assign the IP address:
1. Log in to the appliance via its consoleport using admin as both the username and password.
2. Click the Administration button.
3. Click the Network Settings folder.
4. Click the GB1 (eth0) entry in the table and change the method to Static.
5. Assign the desired IP values and click Apply.
Firewall
Consult the following table to configure access to the appliance through a firewall.
Port Type Service Definition
0 ICMP - Ping srv-PING
20 FTP - Firmware Update srv-FTP-Data
21 FTP - Firmware Update srv-FTP-Commands
22 Encrypted Serial Session srv-SSH-Serial-Session
23 Telnet Session srv-Telnet-Session
69 TFTP srv-TFTP-Services
161 SNMP Set/Get srv-SNMP
162 SNMPTraps srv-SNMP-Traps
443 Encrypted Web UI Access srvWEB-UI
502
Trellis™ Platform (Modbus Communication)
srv-Modbus
514 External Syslog srv-External-syslog
623 Serial over LAN and IPMI NA
843 Web UI Data - Flash srv-Adboe-Flex
1078 DSView™ Proxy Port (Default) srv-DS-View-proxy
2068 Encrypted KVM Session srv-KVM-session
3211 DSView™ Discovery (UDP) srv-Discovery-protocol
3212 UMIQ srv-DRIP-protocol
3502 DSView™ Software Appliance Communications srv-DS-View-plug-in
3871 DSView™ Communication (ADSAP2) srv-Security-protocol
4112 DSView™ Data Logging - Syslog srv-Data-logging-DSView
4440
Trellis™ Management Protocol
srv-UMG-Service-2
Default Firewall Service Definitions