User Guide

134.....Avocent® Universal Management Gateway Appliance Installer/User Guide
Adding a Network Definition
5. Click Policy to add an outbound NATPolicy by entering the following information. Click Apply
when done.
Column Parameter
Direction Outgoing
Order Lowest unused number. Example:1
Interface eth0
Source Name of network definition. Example:PrivNet
Destination any
Service Name of the service definition. Example:srv-SNMP-Traps
Translated Source eth0
Translated Destination any
Translated Service Name of the service definition. Example:srv-SNMP-Traps
Rule State Active
NAT Policy Parameters
6. From the Policy tab, create a firewall policy with the following settings:
Column Parameter
Action Accept
Rule State Active
Destination any
Interface any
Direction Forward
Order Lowest unused number. Example:53
Source Name of network definition. Example:PrivNet
Connection Status Not needed
Firewall Policy Parameters
7. Click Apply when done.
8. From the SP, test sending traps and validate the successful configuration.