User Guide
Targets.....115
4. Select the sensors you want to configure and click Edit. You can configure a sensor’s Name
and Unit as well as its High Critical, High Warning, Low Warning and Low Critical thresholds.
5. Click Apply when finished.
Power Outlet
Available outlet targets can be viewed under the Targets tab.
To view available serial targets:
1. From the sidebar, click Power Outlet and then click on a target to view properties, overview
and settings. You can also turn an outlet on, off or cycle power by clicking the buttons at the
top of the page.
2. Click Properties to view the outlet's ID/nameand status. You can also lock or unlock an outlet
from this page. Alocked outlet cannot be turned on, off or cycled.
3. Click Overview to view the outlet number (ref), current (amps), voltage (volts), power (watts),
AppPower (volt-amps), power factor, energy and alarm state.
4. Click Settings to view and, if supported, configure ID/name, post-on/post-off delays, maximum
current, high warning and high critical thresholds, low warning and low critical thresholds for
the outlet.