User Guide
Targets.....109
Sessions Page Access 2
To close an SP Access session:
1. From the Sessions page, click the box next to the session you want to close.
2. Click Delete.
Power
Click the Power tab to view the power consumption information for the target device. Click Refresh
to refresh the power consumption information.
NOTE: Check the appliance firmware release notes to determine if your SPtype supports this feature.
Power capping
Power capping is a process of reducing or limiting the power consumption allotted to a server.
Implementation of a power cap will vary from server to server and typically relies on assigning
various processor "P"states or processor clocking limits.
Under the Power Capping heading, you can view power information, including status, thresholds,
correction time and sampling period. Fields that aren't supported by the SP/serverwill be grayed
out.
NOTE: The default values are dependent on the SP type.
If supported by the SP/server, you can enable power capping and configure thresholds for the
SP/serverby clicking Configure.
NOTE: Before enabling power capping, consider the possible effect a lower clock rate will have on the
applications hosted by the server.
Power capping can be enabled or disabled and assigned a power threshold watt value.