User's Manual
9. Browse or enter the location of the DSView4 Database in the DSView4 DB field. This is
the postgresbackup.tar file that was extracted from the DSView4 backup
10. Click Next.
11. Assign the servers for migration and click Next.
12. Confirm the server assignments and click Next.
13. Click Finish.
Configure RPM Hub and Spoke server
To configure the hub server:
1. Stop the RPM service on the hub server.
2. Copy the backed up firmware, appliance templates and system properties over to the
corresponding folders on the hub server.
3. Restart the hub server.
To configure the spoke server(s):
1. Stop the RPM service on the spoke service.
2. Copy the backed up firmware, appliance templates and system properties over to the
corresponding folders on the spoke server.
3. Restart the spoke server.
4. Run data replication on each spoke server.
26Rack Power Manager Installer/User Guide