User's Manual

Table B.5 lists the VT100 ANSI mode and cursor keys for set and reset modes. Encoding and
decoding is supported for all the cursor keys listed.
Table B.5: VT100 ANSI Set and Reset Mode Cursor Keys
Cursor Key Mode Reset Mode Set
Up Esc [ A Esc O A
Down Esc [ B Esc O B
Right Esc [ C Esc O C
Left Esc [ D Esc O D
Table B.6 lists the VT100 PF1-PF4 key definitions. Encoding of each listed key is supported;
decoding is not applicable.
Table B.6: VT100 PF1-PF4 Key Definitions
Key Code Sequence
F1 Esc [ O P
F2 Esc [ O Q
F3 Esc [ O R
F4 Esc [ O S
Table B.7 lists the ANSI mode control sequences for VT100 terminal emulation and indicates
Avocent encoding/decoding support, where Yes = supported and No = not supported.
Table B.7: VT100 ANSI Mode Control Sequences
Control Sequence Definition Encode/Decode
Esc [ Pn; Pn R Cursor Position Report No/No
Esc [ Pn D Cursor Backward No/Yes
Esc [ Pn B Cursor Down No/Yes
Esc [ Pn C Cursor Forward No/Yes
Appendices 302