User's Manual
5. Select a time to run the task (see Specifying when to run tasks on page 262), then click
Next.
6. The Select Unit Group window opens. Select All Units or select a unit group, then click
Next.
7. The Select Unit window opens. Select the units to be included in the topology update,
click Add, then click Next.
8. The Select Options window opens.
a. If you enable the Remove offline connections checkbox, any units connections that are
reported as offline in the unit will be deleted from the Rack Power Manager software
database. The Update topology for selected units task does not add offline connections
to the Rack Power Manager software database
b. If you enable the Delete target devices that no longer have connections checkbox,
target devices that no longer have connections will be permanently deleted from the
Rack Power Manager software database.
c. If you enable the Allow target devices with the same name to be merged into a single
target device checkbox, the connection to a target device in the unit will be merged
with the connection(s) to an existing target device in the Rack Power Manager
software database.
d. If you enable the Allow target devices that contain default names to be added for
these type of connections checkbox, you may then enable one or more connection type
checkboxes. Any target devices that contain default names in the unit will be added to
the Rack Power Manager software database only if the connection type in the unit
matches an enabled connection type in this window.
9. Click Finish.
Running tasks manually
Although tasks are scheduled to run at particular times using the Add Task Wizard, you may
run an existing task at any time.
To manually run tasks:
1. Click the System tab.
2. Click Tasks in the top navigation bar. The Tasks window will open.
3. Click the checkbox to the left of the task(s) you wish to run. To select all tasks on the
page, click the checkbox to the left of Name at the top of the list.
274Rack Power Manager Installer/User Guide