User's Manual

2. Click Tasks in the top navigation bar. The Tasks window will open.
3. Click Add. The Add Task Wizard will appear.
4. Select Configure SNMP trap settings on appliance from the drop-down menu. Type a 1-64
character name for the task.
5. Select a time to run the task (see Specifying when to run tasks on page 262), then click
Next.
6. The Select Unit Group window will open. Select All Appliances or select a unit group,
then click Next.
7. The Select Appliance Type window will open. Select the type of managed appliance for
which to configure SNMP traps, then click Next.
8. The Select Appliances window will open. Select one or more managed appliances from the
Available Appliances list, then click Add. The unit(s) will be moved to the Appliances to
Configure list. Then click Next.
9. The Configure SNMP Traps window will open. Change the trap state by selecting one of
the following from each trap menu, then click Next.
• No Change - uses the trap on/off state already configured.
• Enable - turns the trap on.
• Disable - turns the trap off.
-or-
Click one of the following buttons:
• No Change All - uses the on/off states already configured.
• Enable All - turns all traps on.
• Disable All - turns all traps off.
10. Click Finish.
Task: Exporting an event log .csv file
This task exports selected fields from the Rack Power Manager software system event log to a
.csv file. The exported event log may be stored on a local or network drive. The event log is
named eventlog.csv by default, but you may also append the date and time to the end of the
event log. The output .csv file may be viewed in a text editor or spreadsheet application, such
as Microsoft Excel.
Chapter 21: Using Tasks 267