User's Manual

You now have sole read/write privileges to the SSH Passthrough or Avocent Session Viewer
session. Transferring read/write access generates Rack Power Manager software system events.
Disconnecting a session
To disconnect an SSH session:
1. From an SSH Passthrough session, enter the following command:
^Ec.
2. Your session is closed. If you had read/write access to the session, read/write access is
granted to a randomly selected user who is sharing the session.
Displaying session output
If a data log was created for the SSH Passthrough session, you can enter a command to display
the last 30 lines (limited to 16384 characters) of the data log on the SSH client. The last 30
lines may include previous SSH sessions, but will only display target device output, not user
actions.
NOTE: To display session output, data logging must be enabled and the user must have access rights to unit. See
User Access Rights on page 220.
To display session output:
1. From an SSH Passthrough session, enter the following command:
^Ecr
2. The client displays the last 30 lines of the data log.
-or-
If you do not have access rights or if a data log was not created, an error message is
displayed.
Chapter 14: SSH Passthrough Sessions 175