User's Manual

• To add one or more users or user groups, select the users or user groups from the
Available list, then click Add. The users and/or user groups will be moved to the List
to Update list.
• To remove one or more users or user groups, select the users or user groups from the
List to Update list, then click Remove. The users and user groups will be moved to the
Available list.
Click OK. The Unit Access Rights window will contain the current list of users/user
groups. When a user/user group is added to the list, default access rights will be
displayed.
3. To set access rights, select a user or user group from the User and User Groups list, then
enable or disable a checkbox in the Access Rights table for each access right.
• Allow - the access right is allowed for the user/group.
• Deny - the access right is denied for the user/group.
• Inherit - the access right is inherited from the unit group(s) to which the selected
user/group belongs. When Inherit is selected, the Allow and Deny checkboxes will
become gray and unchangeable, and indicate the inherited value. If the inherited
settings indicated both Allow and Deny, the inherited value is Deny, which takes
precedence.
To disable the inherit functionality, uncheck the Inherit checkbox.
• If none of the checkboxes are checked, the access right is neither allowed nor denied.
4. Repeat the preceding step to change access rights for other users/user groups.
5. Click Save and then click Close. The Units View window will open.
Managed Appliance Settings
To change the network settings of a managed appliance:
NOTE: The MAC address cannot be changed.
1. In a Units View window containing appliances (see Accessing Units View windows on
page 111), click on the appliance name.
2. Click Appliance Settings in the side navigation bar and then click Network. The Appliance
Network Settings window will open. To change information:
• Type an IP address, in standard dot notation (xxx.xxx.xxx.xxx).
Chapter 11: Managing Units 145