User's Manual
-or-
If you do not want to apply a configuration template to the appliance, select None and
click Next.
NOTE: For more information about configuration templates, see Appliance Configuration Templates on page 133.
7. Click Finish.
Adding managed appliances from a range or list of IP addresses
To add a managed appliance from a range or list of IP addresses:
1. In a Units View window containing managed appliances (see Accessing Units View
windows on page 111), click Add. The Add Appliance Wizard will open.
2. The Select Add Unit Procedure window will open.
3. To enter IP addresses as a delimited list, click Add multiple appliances, then click Next.
Enter IPv4 and/or IPv6 addresses, separated by either a comma (,) or a semi-colon (;).
-or-
To enter an IP address range, click Discover appliances on the network from an IPv4
address range or an IPv6 subnet, then click Next. Select Use IPv4 address range and
type the IP address from which to begin and end the search in the corresponding fields,
or select Use IPv6 subnet and type the IPv6 network prefix in the corresponding field.
Click Next.
4. The Rack Power Manager software will search for managed appliances within the IP
address range. When the search is completed, the Select Appliances to Add window will
open, listing the results.
5. Add or remove appliances.
• To add one or more managed appliances, select the managed appliances in the
Appliances found list, then click Add. The managed appliances will be moved to the
Appliances to Add list.
• To remove one or more managed appliances, select the managed appliances in the
Appliances to Add list, then click Remove. The managed appliances will be moved to
the Appliances found list.
Click Next.
6. The Select Options window will open. (For more information about the options that affect
adding target devices connected to the appliance, see Topology Synchronization on page
129.)
122Rack Power Manager Installer/User Guide