User's Manual

a. Type the Base distinguished name (DN) from which to begin searches. This is a
required field unless the Directory Service has been configured to allow anonymous
search. Each Search DN value must be separated by a comma.
b. Type the object class. The default value is group.
c. Type the member attribute. The default value is member.
d. Type the username member attribute (only the username, not the full LDAP object
DN). The user’s group membership will be located using this attribute in addition to
the member attribute. This attribute is primarily used with NIS-like schemas.
e. Click Next.
10. The Select Browsing Method window will open.
Click Browse Anonymously to browse users on the external LDAP authentication
server.
-or-
Click Browse with user credentials to browse users on the external LDAP
authentication based on credentials configured on the server. If this option is selected,
do the following:
a. Type a log in ID in the User Name field, in one of two forms: a fully qualified
distinguished name or the username of an account in the base user DN.
b. Type the password for the LDAP user account in the Password field.
c. Click Next.
11. The Establish Connection with Authentication Service window will open briefly. If the
external authentication service is added successfully, the Completed Successful window
will open.
12. Click Finish. The User Authentication Services window will open with the new service
listed.
To change connection settings for the LDAP external authentication service:
1. Click the Users tab.
2. Click Authentication Services in the top navigation bar. The User Authentication Services
window will open.
3. Click the name of the LDAP service. The side navigation bar will change to include the
name of the LDAP service at the top and, below the name, the information you may define.
Chapter 7: Authentication Services 95