User Guide

ICMP protocol fields
If ICMP is selected as a protocol, the ICMP Type pull-down menu is displayed in the ICMP
Options Section at the bottom of the Firewall Configuration form. Select the ICMP type needed
from thelist.
Input interface, output interface and fragments
If an interface (such as eth0 or eth1) is entered in the Input Interface field, incoming packets are
filtered for the specified interface. If an interface is entered in the Output Interface field,
outgoing packets are filtered for the specified interface. The input and output interface fields are
shown in the following table along with the options on the Fragments pull-down menu.
Field Definition
Input Interface The input interface (eth0) for the packet.
Output Interface The output interface (eth0) for the packet.
Inverted
Inverting an item negates the selected rules. Rules will apply to everything except the
selected options.
Fragments
The types of packets to be filtered:
All packets
2nd, 3rd... fragmented packets
Non-fragmented and 1st fragmented packets
Table 7.9: Expert - Firewall Configuration Input/Output Interface and Fragments Fields
LOG target
If you select LOG from the Target field, the fields and menus shown in the following table
appear in the LOG Options Section at the bottom of the form.
Field or Menu Name Definition
Log Level One of the options in the pull-down menu.
Log Prefix The prefix is included in the log entry.
TCP Sequence Includes the TCP sequence in the log.
TCP Options Includes TCP options in the log.
IP Options Includes IP options in the log.
Table 7.10: Expert - Target LOG Options Selection Fields
Chapter 7: Network Menu and Forms 83