FAQ

Rev. A 8
Operation
How do I set the engine exerciser?
To set the exerciser:
1. Press and hold (5secs) the set Engine Exerciser button
2. The exercise period occurs immediately and at the same time weekly thereafter.
3. The status light below the button blinks rapidly to indicate that the exerciser has been set.
4. The number of flashes indicates the number of days until the next exercise periods (at
approximately the same time
the button was pressed).
To cancel an active exercise period
1. Press the set engine exerciser button to stop an exercising generator. If exercise with load is set, the ATS
retransfers the load to the utility, then stops the generator after cool down
How does the ATS work?
See below ATS sequence of operation