Installation Manual

ASCO 5350 Installation Manual
381333-315 D ASCO Power Technologies Page 7
ATS Configuration
The ATS Remote Annunciator must be configured for all the
ATSs that will be monitored and controlled. First log in. The
ATS Remote Annunciator sends HTML files to the client
computer. Internet Explorer interprets these HTML files,
formats them, and displays the pages to the user.
1 Login Screen
To login follow these steps:
1. Be sure that the computer is still connected to the Ethernet
switch (LAN).
2. Start the Internet Explorer browser on the computer.
3. In the address bar, type in the address of the ATS Remote
Annunciator, then press Enter:
http://169.254.1.200
4. The ATS Remote Annunciator login page should appear.
Enter the default Login ( admin ) and Password ( ASCO )
from the label (see page 2) and click Login. See Figure 11.
Figure 11: Login screen
2 ATS Configuration
5. On the left pane, under Configurations, click ATS to
configure the ATSs that will be monitored. See Figure
12.
click
Figure 12: Configurations > ATS
6. The Configurations > ATS screen appears. See Figure 13.
Select either Single ATS or Multiple ATS based upon the
communication architecture of the ATSs and press the
corresponding Go button under the selection:
Single ATS connected to one Connectivity Module (CM)
- each ATS having its own Connectivity Module
Multiple ATS connected to one Connectivity Module
- all ATSs connected through a single Connectivity Module.
Figure 13: Single or Multiple ATS configuration
2-1 Single ATS connected to one CM
You must know the IP address of the Connectivity Module
(CM) that corresponds with the ATS (and Power Manager, if
present) in the network. The ATS Remote Annunciator has an
auto discovery feature for a scenario in which one ATS is
connected to one CM. The user has to input the IP address
details of the CM to which the ATS is connected. After
performing the auto discovery, the information about the
discovered ATSs is displayed on the web interface. See Figure
14.
Figure 14: Single ATS screen
1. To perform the auto discovery of the ATSs, enter the IP
address of the CM to which the ATS is connected, select
the check boxes next to each ATS, then click Automatic.
See Figures 15 and 16.
Figure 15: Auto Discover in Process