Manualshelf

Installation Manual

ManualsBrandsEmerson ManualsPower Switching and ControlsEmerson ASCO 5140 Quad-Ethernet Module (Acc. 72EE)
12345678910
5140 Quad-Ethernet Module Webpage Interface 3-1
Webpage Interface
The 5140 QEM has built-in web pages that allow the user to monitor and control the downstream capable devices
made by ASCO Power Technologies. A computer (or any web-enabled product, including smart phones and tablets)
and a connection to the 5140 QEM over Ethernet will give the user access to data.
User Requirements
The user has a computer or web-enabled device that has been configured to communicate over a network to
the 5140 QEM. The most common web-enabled device would be a computer and the most common network
connection would be over a LAN (local area network). The setup and testing of this network can be viewed
in the Configuration area of this manual.
The user has been provided the IP address of the 5140 QEM as well as a User Name and Password for access.
It is possible that the information is still the default settings but may have been changed during setup.
The user’s intranet access software or web browser needs to be one supported by the 5140 QEM. The 5140
QEM supports most web browsers but was designed for Internet Explorer 8.0 or higher.
Getting Connected to the 5140 QEM over the Ethernet
Open the web browser of the web-
enabled device that will be used to
view the 5140 QEM web pages.
The default IP address is
169.254.1.1. Type the correct IP
address in the address bar and press
Enter. See Figure 3-1.
The webpage should show a Login
page. If the webpage appears it
indicates that all of the network
configurations were done correctly.
If the Login page is not displayed,
the setup needs to be reviewed.
Common causes for not being able
to connect to the 5140 QEM could
be: It is not powered on, duplicate
IP address, cables not connected, or
gateway address/network settings.
Also refer to the troubleshooting
section.
Type the User ID and Password
and click Login. Refer to page
2-1. When a correct user name and
password is entered the dashboard
page should appear.
Figure 3-2. Dashboard page (typical for New Series 300 Transfer Switch with Acc. 72EE)
Figure 3-1. Login screen.
address bar