Installation Manual

5140 Quad-Ethernet Module Access Levels and Passwords 2-1
Access Levels and Passwords
The 5140 QEM has three different levels of user access. The importance of these levels varies based on the interface
method that is selected. The 5140 QEM is shipped with three preset user IDs and default passwords. The three user
IDs cannot be changed. The passwords can be changed by the admin level user. During the initial on-site
configuration the passwords should be changed as needed.
User IDs
(lower case)
cannot be chan
g
ed
Access Level
Default Password
(upper case)
15 characters maximum
New Password
monitor
View access: can view status and
webpages, cannot transfer or
retransfer load, or make chan
g
es.
ASCO
control
Control access: can transfer and
retransfer load (ATS), cannot change
an
y
confi
g
uration settin
g
s.
ASCO
admin
Full access: can set passwords and
change all configuration settings of
the 5140 QEM.
ASCO
Be sure that users to whom you give control access are those
persons that you want to be able to control the electrical system.
How to change a password
On any QEM web page, click the Configuration tab. Click the Press to
Change Password button. In the Change Password window, type the
User ID (admin level), type the old password and the new password. Then
click Submit, and a message should indicate that the password was changed.
Figure 2-2. Change password screen.
Addresses
The MAC address and the default IP address are located on the outside of the 5140 QEM. Refer to the About
webpage for determining the IP address and MAC address.
A
ddress Default Address New Address
IP Address 169.254.001.001
MAC Address 00:0C:99:____:____:____.
The MAC Address cannot be
chan
g
ed b
y
the use
r
NOTIC
E
Figure 2-1. Configuration screen.
Type monitor, control, or
admin (lower case).