Installation Manual

5140 Quad-Ethernet Module Types of Data/Control Appendix-3
Types of Data/Control found on Web pages
The following types of data and control are provided on 5140 QEM web pages, depending on the connected devices.
Transfer Switch Dashboard web page (for New Series 300 Transfer Switch with Group G Controller)
Switch Status, Active Alerts, Timers
Transfer Switch – Control Capability (firmware version 11 or higher)
Voltage, Frequency, and Current Monitoring
Transfer Switch / Generator Statistics
Transfer Switch Details web page (for New Series 300 Transfer Switch with Group G Controller)
Pickup and Dropout Voltage Settings (settings for view only)
Frequency Trip Settings
Engine Exerciser Settings
Active Alerts and Timers
Transfer Switch and Engine Status
Power Meter Dashboard web page
Energy Consumption – Net KWH, KVAR, KVA
Transfer Switch Rated Current Utilization
Power Quality (THD)
Power Measurement – KW, KVA, KVAR, PF
Voltage (L-L and L-N), Frequency, and Current Measurement
Current date and time
Power Meter Details web page (settings are view only)
Energy Consumption
Historic KW Demand
Maximum Load Demand Chart
Power Measurement – KW, KVA, KVAR, PF
Voltage, Current, Frequency, Power, and PF Measurement
PT and CT ratios
Event Log page (5140 QEM displays up to 300 events with Accessory 11BE)
Events page shows the controller events logged into the 5140 QEM. Data included: event type, cause, timestamp.
Configuration web page
There are two Configuration pages. One is viewable only; the other allows changes to the settings (Admin level).
Viewable and editable are IP, TCP, and Communication Settings as well as SNMP and SMTP settings.
The user can change device names and locations (these are only changes that can be made to downstream devices).
The Configuration section is where a user can change the passwords (see page 2-1).
Firmware Upgrade access (see Appendix 1).
About page
The About page provides firmware versions of the 5140 QEM and devices that are connected downstream.