User Guide

Program Installation and Options
4-4
6. It is recommended to replace the regular BMDM shortcut on the desktop with the
Run BMDM Service in Session shortcut to prevent the user from launching the
BMDM incorrectly.
4.5. Database Notes
A BMDM database file contains cell and battery readings and setup data. The BMDM
program stores MPM and BDS data in an Access-based .MDB file.
Access initial database file - During installation, the BMDM places the empty Access
database file mpm-db3.mdb under Program Files\Alber\MPM Manager\Database or in
another folder selected at time of installation. This empty default database opens when you
have not previously opened another database.
Creating a new database - You may create a new Access database using File|New.
Deleting a database - You cannot delete an Access MDB database file from within the
BMDM program. To delete a database, use standard Windows procedures to delete the MDB
file from the folder where it is saved. The file is typically located at Program Files/Alber/
MPM Manager/Database.
Because databases may contain unrecoverable battery data, regularly back up MDB files to
another computer to help prevent data loss. Refer to Automatic and Manual Backup.
4.6. Default Passwords
The BMDM program has one default password, alber, which accesses all areas of the
program and can be changed by the user. It is important to note that different passwords may
be selected for various program areas. New passwords may be alphanumeric and are not case
sensitive.
Additional passwords may be needed when using options. For example, when setting up an
email account for alarm notification, the password is determined externally and is not
changeable using the BMDM. Be certain to record new passwords for reference. If lost, they
cannot be retrieved, and you will have to contact Alber for an unlock code.
System Setup Password - A password for System Setup is stored in the BMDM database
and may be eight characters long. To change it, from the String Status screen, select
Setup|System|Password. Refer to System Setup: Password.
Battery Setup Password - A password for the Battery Setup, Calibration, Diagnostics, and
Check Settings Upload screens is stored in MPM or BDS firmware and must be five
characters. To change it, from String Status, select Setup|Battery|General. Refer to Battery
Setup: General (MPM or BDS).
The Battery Setup password is cleared from the MPM or BDS firmware when the
Alarm Reset switch clears existing names. Refer to the Clear Existing Names (On-site) text in
the Synchronizing Using Check Settings chapter.