User Guide

Error Codes
30-2
CODE
MESSAGE
SITUATION
203
The currently selected COM Port, COM
<ComPortNum>, is already in use by another
program. Press OK and choose a different port.
When initializing COM port
204
The currently selected Com Port, Com
<ComPortNum>, is not available. Press OK and
choose a different port.
When initializing COM port
205
No response from Modem/Cable Multiplexer.
When connecting
modem/cable multiplexer
206
Comm Error: No response for sending "Stop Scan"
command 3 times.
207
Comm Error: No response for sending "Start Scan"
command 3 times.
208
Comm Error: No response for sending "Load Off"
command 3 times.
209
Comm Error: No response for sending "Send DCM #"
command 3 times.
300
Upgrade failed: No response for sending code 3 times.
When sending frames
301
Upgrade failed: Not responding.
Check firmware location
(PROM or flush memory) in
the beginning of firmware
upgrade
302
Upgrade failed: Code confirm failed.
400
Resistance test failed: 60 minute time-out.
Manual R-test is not
completed in 60 minutes
401
Data format error. The data may be saved for a
different MPM configuration.
When reading resistance or
historical data
402
The raw count equals 0. Please check hardware.
During calibration
403
Data import error (Encode date/time). Please try
again.
When importing alarm data
404
Wrong overall voltage data.
Got invalid overall voltage in
discharge data
405
Subset <SubsetNum> does not have an initial value.
When viewing discharge
curves, found invalid subset
406
Subset <SubsetNum> does not have a final value.
When viewing discharge
curves, found invalid subset
407
Discharge data cannot be shown due to invalid
Date/Time.
500
Subset 3 is selected, but Subset 2 is not selected. If
you want to show two curves, the second curve
should be in Subset 2.
Wrong selection in Curve
Option of Discharge View
screen
501
Two password entries are not identical. Please enter
again.
502
Password must have five characters.
1000
The string name exists. It must be unique.
1001
The battery name exists. It must be unique.
1002
The location name exists. It must be unique.
1003
The customer name exists. It must be unique.