User Guide

Using the Report Generator
22-10
22.10. Discharge Report
String View > View|Reports|Discharge
To create a Discharge report, click Discharge. The Discharge Setup box appears. Options
selected on Discharge Setup are saved by the battery name.
Figure 105. Discharge Setup
Report Interval area - Click Time or OV (Overall Voltage) Deviation and type a value in
the respective box. Report Interval determines the frequency of report sampling. Specify time
in hours, minutes, and seconds (10 second minimum) or OV deviation in volts (0.2 volt
minimum).
Low Threshold Values area - Click Use Preset Thresholds to use values set in the BMDM
program when the test was run. Click Override Preset Thresholds to ignore BMDM
thresholds, then type values in the Low Cell Threshold and Low OV Threshold boxes. Any
measurement below these values will be in violation.
Graph Scaling area - Click Auto to default to automatic graph scaling, or click Manual and
type the Max and Min graph scale values. Use Manual scaling when you want to maintain
scaling to make it easier to compare several graphs.
Select Auto Select to automatically select cells listed on the right side that violate thresholds.
If you change cell or OV threshold values, cells that meet the new criteria are selected. You
may add cells to the report by selecting additional check boxes in the list.
Select String Memos and Cell Memos to include string memos and cell memos.
Select Include Power to list power in reports, in addition to voltage and current.
Select Standard to create a Standard report. Cells are listed by string, and strings are listed
by time in a Cell = Value format.