User Guide

Safety Information
1-1
1. Safety Information
 You must read and understand these safety precautions and those elsewhere in this manual
before installing, powering up or using the system.
 Except as explained in this manual, do not attempt to service Albér equipment yourself.
Opening the equipment may expose you to dangerous voltages. Refer servicing beyond that
described in this manual to authorized personnel.
 Do not allow liquids or moisture to get into the equipment. If liquid gets into the equipment,
unplug it immediately and contact an authorized service center or Albér.
 The equipment must have adequate ventilation. Do not block equipment ventilation openings.
 Do not exceed equipment voltage, power ratings or capabilities.
 When grounding is required, make sure the equipment is properly grounded.
 Do not let unauthorized persons operate the equipment.
 Do not energize the cabinet or any component with 115VAC (or 230VAC if applicable) or
battery voltage until after the installation is complete.
 Use of this product in a manner not specified could compromise the designed-in safety of this
product.
 High voltage or current may be present inside the equipment and on the equipment terminals.
Only qualified personnel should perform the operations described in this manual. Calibration
must be performed only by technically qualified persons. Observe electrical safety
precautions when removing and installing equipment covers, when connecting leads, and
when making adjustments.
 Proper installation and testing are essential to the correct functioning of your system. If you
have any questions, contact Albér.
 This manual describes the general installation and use of the system. If your system has
features or accessories not described in this manual, contact Albér.
 Drawings in this manual may be for reference only or superseded by later drawings. For the
latest information, refer to the drawings supplied with your system.
1.1. If You Have Questions
If you have any questions about the installation or testing of your system, contact Albér at
[phone] or fax [phone]. Request BMDM, MPM or BDS assistance.