Brochures and Data Sheets

Surge Protection

For Business-Critical Continuity

™

Liebert ACG Series

AccuGuide High-Performance Interconnect Assemblies For

Systems With Parallel Surge Protection Devices

Interconnect made of conventional wire in conduit distributes

line power, but reduces the performance of surge suppressors.

The patented Liebert ACG Series (AccuGuide) interconnect

allows you to get the most from your SPD by significantly

reducing clamping voltages.

Liebert ACG Series interconnect assemblies can maximize

performance by transmitting transients generated by

lightning and switching with minimal voltage drops.

Each Liebert ACG Series unit is an assembly of patented

coaxial cables. (One AccuGuide coaxial cable is required

for each protected mode.) Each cable minimizes

inductance (through reduced coaxial aspect ratios), and

features an extremely low impedance (2-10) unattainable

in conventional interconnect. As a result, the assembly

delivers practically the entire surge to the Surge

Protection Device (SPD). Clamping voltages are greatly

reduced and system performance is improved.

Liebert ACG Series is designed to aid any installation.

This accessory is especially valuable in cases where the

SPD cannot be installed close to the point of protection

(greater than five feet). In conventional interconnect,

voltage loss increases with length — in excess of 16V/ft/kA

for an ANSI/IEEE, C62.41 combinations wave. In contrast,

Liebert ACG Series AccuGuide losses are under 4.2V/ft/kA

for an improvement of 400%.

PAGE 1
Surge Protection For Business-Critical Continuity™ Liebert ACG Series AccuGuide High-Performance Interconnect Assemblies For Systems With Parallel Surge Protection Devices Interconnect made of conventional wire in conduit distributes line power, but reduces the performance of surge suppressors. The patented Liebert ACG Series (AccuGuide) interconnect allows you to get the most from your SPD by significantly reducing clamping voltages.
PAGE 2
Emerson Network Power AccuGuide Coax Construction Primary & Secondary Insulation Jacket Conductor Outer Braid Inner Braid Ordering Information: AccuGuide cable assemblies are available in several standard lengths for any service configuration with up to seven modes of protection. The conductor gauge is configured to accommodate the system.