Specifications

Types of Mounting Installation • 5
3 Installation
3.1. Types of Mounting
The Energy Meter can be mounted in two ways: on
standard 35 mm DIN rail or screw-mounted to the in-
terior surface of the enclosure.
3.1.1. DIN Rail Mounting
1. Attach mounting clips to the underside of the Ener-
gy Meter by sliding them into the slots from the in-
side. The outside edge of the clip must be flush with
the outside edge of the Energy Meter.
2. Snap the clips onto the DIN rail. See diagram of the
underside of the Energy Meter (below).
3. To prevent horizontal shifting across the DIN rail,
use two AV02 end stop clips.
3.1.2. Screw Mounting
1. Attach the mounting clips to the underside of the
Energy Meter by sliding them into the slots from the
outside. The screw hole must be exposed on the out-
side of the housing.
2. Use three #8 screws (not supplied) to mount the En-
ergy Meter to the inside of the enclosure. See dia-
gram of the underside of the Energy Meter (below).
WARNING! Disconnect power prior to instal-
lation.
Any covers that may be displaced during the
installation must be reinstalled before powering the
unit.
Mount the Energy Meter in an appropriate electri-
cal enclosure near equipment to be monitored.
Exposure to VFD harmonics may cause permanent
damage to this device.
Figure 3-1 - DIN Rail Mounting
Figure 3-2 - Screw Mounting