Technical data

Chapter 5
AXP 1410 Installation and Use (6806800H70D)
79
Configuring and Operating the System
5.1 Overview
The following sections provide information that you need after you have successfully installed
the hardware.
5.2 Network Management
Before accessing the system components, you need to be aware of various network addresses.
The following subsections describe the default addresses and how they can be changed.
Section Description
Network Management on page 79 This section contains information on VLAN configuration,
slot numbering, IPMB and hardware addresses, and IP
addresses of SAM1410.
Accessing System Components on page 99 This section contains information on which component
can be accessed via which interface and where you can
find additional documentation.
Software on page 100 This section contains information on which software is
installed on the system components and what tools can
be used for software upgrades.
Power Entry Module (PEM) on page 102 This section contains information on power supplies.
Fan Tray Modules on page 104 This section contains information on fans.
Redundancy on page 106 This section contains information on cold standby, dual
star network topology and actions of shelf manager and
system manager during switchover, takeover, failover,
insertion, and extraction.
Blade Insertion and Extraction on page 116 This section contains information about the steps carried
out by the software when a blade is inserted or supposed
to be extracted.
The information in the following subsections assumes that you have set the shelf address on
both shelf manager boards to the same value via the rotary switches.