Technical data

Chapter 6
AXP 1410 Installation and Use (6806800H70D)
119
Supported IPMI Commands
6.1 Introduction
This chapter describes the different commands supported by the AXP 1410 series platforms.
Command categories are as follows:
z Standard IPMI Commands
z PICMG 3.0 Commands
6.2 Standard IPMI Commands
The IPMC is fully compliant to the Intelligent Platform Management Interface v.1.5. This
section provides information on which IPMI commands are supported on PEMs and fans. Table
entries marked with an “X” indicate which FRU supports a listed command. IPMI information
for blades can be found in the respective blade documentation.
6.2.1 Global IPMI Commands
The IPMC supports the following global IPMI commands.
6.2.2 Event Commands
The IPMC supports the following event commands.
Table 6-1 Supported Global IPMI Commands
NetFn Rq/Rs Command CMD PEMs FTMs
Get Device ID 0x06/0x07 0x01 X X
Table 6-2 Supported Event Commands
Command NetFn Rq/Rs CMD PEMs FTMs
Set Event Receiver 0x04/0x05 0x00 X X
Get Event Receiver 0x04/0x05 0x01 X X