Technical data

Configuring and Operating the System
AXP 1410 Installation and Use (6806800H70D)
102
Please refer to the Release Notes to find out about software dependencies.
5.5 Power Entry Module (PEM)
This section discusses the operations of the Power Entry Module.
5.5.1 Description
The AXP 1410 has PICMG 3.0 compliant, dual PEMs and is rated for normal -48VDC to
-60VDC. The PEMs plug directly into the midplane and deliver power to the backplane. Each
input is rated for 80 amps. The two 80 amp feeds each power eight AdvancedTCA slots and the
upper and lower FTMs. Each PEM also generates a separate +12V for redundant powering of
the SAMs. This voltage is distributed to each of these modules across the backplane.
Fan tray firmware upgrade FUMI System Management Interface Based on HPI-B (Centellis
31kX/4100/2000/4410) User’s Guide
Chapter: Using the Firmware Update Management
Instrument
fw_tool SAM1410 Installation and Use
Chapter: Software Upgrade
PEM IPMI firmware upgrade FUMI System Management Interface Based on HPI-B (Centellis
31kX /4100/2000/4410) User’s Guide
Chapter: Using the Firmware Update Management
Instrument
fw_tool SAM1410 Installation and Use
Chapter: Software Upgrade
Table 5-3 Available Software Upgrade Tools (continued)
Procedure Tool Document/Chapter