Warranty

11
2
3
4
5
Handling the remote controller ......................................................
Remote controller Specifications...................................................
Function buttons .................. ..........................................................
How to use the buttons ...................................................................
Auto operation.............................................................................................................
Cooling/Heating/Fan operation..................................................................................
Dehumidifying operation ...........................................................................................
Timer operation .........................................................................................................
Energy saving operation ...........................................................................................
CONTENTS
Use the remote controller within a distance of 5
meters from the appliance, pointing it towards
the receiver. Reception is confirmed by a beep.
Location of the remote controller.
5m
CAUTIONS
The air conditioner will not operate if curtains, doors or other materials block
the signals from the remote controller to the unit.
Prevent any liquid from falling into the remote controller. Do not expose the
remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight,
the air conditioner may not function properly. Use curtains to prevent the
sunlight from falling on the receiver.
If other electrical appliances react to the remote controller, either move these
appliances or consult your local dealer.
Handling the remote controller
22
SleepSleep
CFhiletecrkCFhiletecrk
FoMlleow FoMlleow
AutoAuto
On/offOn/off
FanFan
HighHigh
Med Med
LowLow
ESnaevregryESnaevregry
onon
offoff
TimerTimer
AutoAuto
FanFan
CoolCool
DryDry
ModeMode
TEMP/TIMERTEMP/TIMER
TEMP/TIMERTEMP/TIMER
HeatHeat
5
5
6
7
9
Installation instructions of battery
Step 1: Insert a coin vertically in the groove
on the battery cover, clockwise rotation of 45
degrees, make sure that the groove is aligned
with the "unlock" sign as shown below
and remove the battery cover.
Step 2: Install battery inside the remote
controller, the positive (+) side up.
Step 3: Install the battery cover, make
sure the battery cover groove is aligned
with the "unlock" sign. Insert a coin
vertically in the groove and press it
gently, then counter clockwise rotation
of 45 degrees, make sure the groove is
aligned with the "lock" sign as shown
below.
Coin
Battery cover
Groove
Lock sign
Unlock sign
Groove
Unlock sign
Battery cover
Battery
Positive (+) side up
Coin
Groove
Battery cover
Unlock sign
Lock sign
Coin
Groove
Battery cover
Unlock sign
Lock sign
Lock sign
Coin
WARNING
1. Battery must be disposed of properly. Do not
short circuit or dispose of in the fire.
2. Keep batteries out of the reach of children.
3. Caution for ingestion.
4. Non-rechargeable batteries are not to be
recharged.
5. Exhausted batteries are to be removed from
the product.
WARNING:
Chemical Burn Hazard. Keep batteries away from children.
This product contains a lithium button/coin cell battery. If a new or
used lithium button/coin cell battery is swallowed or enters the body,
it can cause severe internal burns and can lead to death in as little as
2 hours. Always completely secure the battery compartment. If the
battery compartment does not close securely, stop using the product,
remove the batteries, and keep it away from children. If you think
batteries might have been swallowed or placed inside any part of the
body, seek immediate medical attention.
The cells shall be disposed of properly, including keeping them away
from children. Even used cells may cause injury.