420_QIG_Rev_CA.
1420_QIG_Rev_CA.fm Page 2 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway © 2007 Rosemount Inc. All rights reserved. All marks property of owner.
1420_QIG_Rev_CA.fm Page 3 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway STEP 1: INITIAL CONNECTION FOR CONFIGURATION To configure the 1420 Wireless Gateway, a local connection between a PC/laptop and the 1420 Wireless Gateway must be established.
1420_QIG_Rev_CA.fm Page 4 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 1420 Wireless Gateway 00825-0100-4420, Rev CA June 2007 c. Select Internet Protocol (TCP/IP), then click the Properties button d. Select the Use the following IP address button and set the IP address to 192.168.1.12 e. Set the Subnet Mask to 255.255.255.0 f. Select OK for each of the settings windows that have opened. 3.
1420_QIG_Rev_CA.fm Page 5 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway 4. Open a standard web browser (Internet Explorer, Mozilla Firefox or similar). 5. Uncheck proxies (Tools>Internet Options>Connections>LAN Settings) 6. Access the 1420’s default web page at https://192.168.1.10 a. Log on as User: admin b.
1420_QIG_Rev_CA.fm Page 6 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 1420 Wireless Gateway c.
1420_QIG_Rev_CA.fm Page 7 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway STEP 2: BASIC SECURITY AND TIME CONFIGURATION To configure the basic security of the 1420 Wireless Gateway, perform the following steps. 1. Navigate to Setup>Security>User Accounts 2. Set and confirm new passwords for each of the access levels 3. Click Submit 4. Navigate to Setup>Time 5.
1420_QIG_Rev_CA.fm Page 8 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 1420 Wireless Gateway 00825-0100-4420, Rev CA June 2007 STEP 3: BASIC ETHERNET OR SERIAL CONFIGURATION To configure the 1420 for an Ethernet Network: Table 2: Ethernet Communication Settings on page 15 is available to assist in recording the necessary information. 1.
1420_QIG_Rev_CA.fm Page 9 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway STEP 3 CONTINUED... To configure the 1420 for a Serial connection: Table 4: Serial Communication Settings on page 15 is available to assist in recording the necessary information. 1. Configure 1420 Serial Communication Settings a. Access the 1420 Web Interface with Administrator access b. Navigate to Setup>Modbus>Communication c. Click Enable Modbus d.
1420_QIG_Rev_CA.fm Page 10 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 1420 Wireless Gateway 00825-0100-4420, Rev CA June 2007 STEP 4: MOUNT AND CONNECT THE 1420 Integral Antenna with the 1420 on a Mast The optimal installation of the 1420 Wireless Gateway is on a pole approximately 1.8 meters above the top of the exterior wall of a building. The following hardware and tools are needed: • Pipe mount with holes spaced 3.06 inches (78 mm) apart horizontally and 11.
1420_QIG_Rev_CA.fm Page 11 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway STEP 4 CONTINUED... Connect to Information System 1. Wire the 1420 Primary Ethernet output or Serial Output connection to the Host System Ethernet or Serial input connections. 2. For Serial connections, connect A to A, B to B and make sure all terminations are clean and secured to avoid wiring connection problems. Figure 1.
1420_QIG_Rev_CA.fm Page 12 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 1420 Wireless Gateway 00825-0100-4420, Rev CA June 2007 PRODUCT CERTIFICATIONS Approved Manufacturing Locations Rosemount Inc. – Chanhassen, Minnesota, USA Telecommunication Compliance All wireless devices require certification to ensure that they adhere to regulations regarding the use of the RF spectrum. Nearly every country requires this type of product certification.
1420_QIG_Rev_CA.fm Page 13 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway Canadian Standards Association (CSA) N6 CSA Division 2 & Dust Ignitionproof Certificate Number: See Certificate Suitable for Class I, Division 2, Groups A,B,C,D; Dust Ignitionproof for Class II, Groups E,F, and G; Suitable for Class III Hazardous Locations. Install per Rosemount drawing 01420-1011.
Local 1420 HMI (Covered) POE S P2 (Secondary) - AMS P1 (Primary) A B Modbus - - Not Used OPC Application + + Not Used S S Not Used - - Not Used Modbus TCP S S DCS / PLC + + DCS/PLC HMI 1420 Wireless Gateway Remote 1420 HMI For P2 and POE connectivity options, see the 1420 Wireless Gateway Manual, document number 00809-0100-4420. Case + 24 V DC Power Input Serial Serial Input Card 1420_QIG_Rev_CA.
1420_QIG_Rev_CA.fm Page 15 Thursday, June 7, 2007 1:18 PM Quick Installation Guide 00825-0100-4420, Rev CA June 2007 1420 Wireless Gateway Table 1. Ethernet Port Locations Settings Location 1420 Ethernet Port P1 Information System Switch or Access Point Switch or Access Point Ethernet Port Table 2. Ethernet Communication Settings Setting Value Options Use Fixed IP or DHCP? Fixed IP Address or DHCP Host Name Netmask (Subnet Mask) Gateway Fixed or DHCP XXX.XXX.XXX.XXX or XXXXXXX YYY.YYY.YYY.YYY ZZZ.
1420_QIG_Rev_CA.
