- Emerson Electric Co. Computer Monitor User Manual

Page 44
MSL600
Installation, Operation & Maintenance Manual
IP262/Z0, Rev. AB
February 2012
7.10.5 COMMS parameters P710 to P716
These parameters are used for serial RS232 communications.
7.10.5.1 Address - P710
Poll Address. The default value of this parameter should not be changed. The parameter is included in the
menu system for future software updates. Default = 0
7.10.5.2 Interface - P711
The type of serial interface. The default value of this parameter should not be changed. The parameter is
included in the menu system for future software updates. Default = log download
7.10.5.3 Baud Rate - P712
The speed of transfer of the interface in bit/s. The default value of this parameter should not be changed. The
parameter is included in the menu system for future software updates. Default = 9600
7.10.5.4 Start Bits - P713
The number of start bits. The default value of this parameter should not be changed. The parameter is included
in the menu system for future software updates. Default = 1
7.10.5.5 Data Bits - P714
The number of data bits between start and parity bit. The default value of this parameter should not be changed.
The parameter is included in the menu system for future software updates. Default = 8
7.10.5.6 Parity - P715
Whether an even or odd parity check bit has been added. The default value of this parameter should not be
changed. The parameter is included in the menu system for future software updates. Default = even
7.10.5.7 Stop Bits - P716
The number of stop bits. The default value of this parameter should not be changed. The parameter is included
in the menu system for future software updates. Default = 1
7.10.6 SETTINGS parameters P730 to P737 and BASE UNITS selection
7.10.6.1 Base units
The user can select either metric units (metres, deg C) or imperial units (Feet, degrees F)
7.10.6.2 Date - P730
The current date is entered here.
7.10.6.3 Time - P731
The current time is entered here.