- Emerson Remote Terminal Unit Instruction Manual

CI-ControlWave Express Installation & Operation / 2-33
5. When the FLASH is ready for download the letter C will be displayed on the screen. In
the HyperTerminal command bar click on Transfer and then Send File (see Figure 2-
23). In the Send File Dialog Box (see Figure 2-24), select “1KXmodem” for the protocol,
enter the filename of the appropriate .bin file in the format “e1sxxxxx.bin” or
“e3sxxxxx.bin” (where xxxxx varies from release to release). Click on the Send button to
start the download (see Figure 2-24). When the HyperTerminal Recovery Mode Menu of
Figure 2-22 appears, the download has completed.
6. Close the HyperTerminal program. The null modem cable connected between the
ControlWave Express and the PC can be removed if desired.
7. Set the CPU/System Controller Board’s Mode Switch (SW1) for ‘Local Mode,’ i.e., set SW1-
3 OFF. Then switch power OFF/ON.
Once the ControlWave Express is running its application load, status codes are posted to the
LCD Display (if present) and the Status LEDs on the CPU’s LED Board. These Status LED
Codes are listed in Table 2-12.
Figure 2-23 - HyperTerminal FLASH Download Menu
(Ready to Download) - (Transfer/Send File Selected)
Figure 2-24 - HyperTerminal Flash Download (Send File Dialog Box)
Click here to return to Table of Contents